Flattening the ends of a penblank where a pen tube has been glued in can be a challenge. Sawing and sanding to a fraction of a millimetre is not the best method to tackle this. If you cut off even a tiny bit too much or too little, there is a chance that the pieces will not fit together perfectly.
A milling head is mounted on a rod that fits into the penstock. This rod can be attached to a chuck that fits into a column drill, drill press or the chuck of a lathe. The penblank should be clamped in place. The part with the trimmer should be able to rotate.
See the video from 6 minutes and 26 seconds to see this in use with a drill.
Contents: 1 router and 4 rods that fit into 7, 8, 9.5 & 10 mm penblanks.
Properties
- PBTK05
- Planet Plus
- 5407008212117
- 5060939742254
